All in one Filtration, UV Clarifying and Fountain kit systems
Our All in One product we are currently using is the MF 3000. This all-in-one pump incorporates new technology with a combination of pump, biological filter with filter sponge and uv-clarifier. There is also the added bonus of a fountain kit and optional 9W UV Clarifier lamp for algae control.
With these products regular maintenance is the key. Sponges get blocked with debris, due to pump suction, reducing water flow.
When fountain flow reduces it is time to clean - don't leave maintenance to long as damage or pump overheating may occur.
These sponges need to be cleaned regularly (preferably in a bucket of pond water). Do not use with chlorinated water or bleach or you will destroy the "good" bacteria ecology that has grown in the sponge. Rinse off the heavy debris and squeeze out excess sediment. Do not WRING our the sponge or you will damage this and you will have to invest in a replacement sooner than required.
All in One Filtration pump MF3000
The advanced filter box features 4-layer filtration
- Coarse sponge (catches large waste)
- Fine sponge (captures fine debris)
- Ceramic rings (cultivates beneficial bacteria)
- and bio-balls (improves oxygen levels)
All elements combine to maintain clean, healthy water for your water garden plants and pond fish
You can also invest in the optional 9W UV Clarifier with this unit for algae control.
The Filter unit and UV Clarifier are sold with separate power plugs to give you the option of turning off your UV Clarifier over winter when it is not required allowing for longevity of your UV bulb.
** A UV bulb has suggest usage of 8000 hours (or 1 year)
The 4 way filtration provides water clarity with the additional biological support to support a balance in your pond, water feature or water bowl.
With the added inclusion of a UV Clarifying lamp for algae control this system can offer a complete filtration system.
The MF3000 is easy to Install and maintain.
NOTE:
This unit has two power cords for the pump and the UV clarifier.
This system allows the UVC lamp to be turned off during winter to extend the lamp life.
No fiddling with changing UV bulbs and worrying about O-rings - the new UV unit is as easy as take out an put in!
Use the MF3000 as just a Fountain
or... Divert water from the Fountain to make a waterfall or stream or join to a Water feature
or... Use a filtration unit and pump the water to a waterfall, stream or water feature
Additional Maintenance information
The MF3000 has two filter sponges, one course sponge and one fine sponge.
Both sponges require regular cleaning to keep the pump, fountain and filtration running at optimal levels. Blockage of the sponges can cause a restriction of water with possible overheating and pump damage.
The sponges trap and filter particulates and debris so the water released from the pump is cleaned. The design of the MF3000 does not require it to be raised from the bottom of the sump/pond, however it may be some thing to consider to reduce silt and debris being sucked into the filter box.
Cleaning: Turn off the power. Remove the pump from the water and drain. Remove both sponges and wash with rainwater or in a bucket with pond water. . Keep cleaning until the water runs clear. DO NOT wring out sponges. Sponges will need to be replaced when worn out.
DO NOT USE CHLORINATED TAP WATER to rinse your sponges as the chlorine will kill the "good bacteria and micro-organisms" living in your filter media
If excessive blocking occurs clear the pond/water feature of the large debris with a net or pond vacuum.
OPTIONAL: Remove the fine impellor sponge to increase flow. Note: Removal of this sponge can cause additional wear on the impellor and shaft with possible blockage of the fountain unit (if in use).